When adding WiFi / IP devices such as Foscam or Sonos, make sure you've connected them to the same local network as your Cozify hub - most often this is done by connecting your hub to your home's WiFi Router via Ethernet cable.
Note: If you are adding an already previously paired device, reset the device first according to the device's manual's instructions.
In general, activate the new device's pairing mode according to the device's manual, and then proceed adding/pairing the device to your Cozify hub as follows:
Z-Wave devices
To add new Z-Wave devices to Cozify hub, first turn on the device's pairing mode on according to the device's own manual instructions. Then follow these steps in Cozify:
1.
Go to Devices view
2.
Press (+) icon in the header
3.
Press "(+) Add Device Manually"
4.
Press "Add Z-Wave devices"
5.
Follow on screen instructions.
ZigBee devices
To add new Z-Wave devices, follow these steps in Cozify:
1.
Go to Devices view
2.
Press (+) icon in the header
3.
Turn device's pairing mode on (please see device's manual for more information)
4.
Wait for the new device to appear automatically in the "Devices found" list (within 10-15 seconds) and press (+) to add the device
- If the device doesn't appear in the list, re-activate the pairing mode for the device and try again, or try adding the device manually (step 5).
- If the device doesn't appear in the list, re-activate the pairing mode for the device and try again, or try adding the device manually (step 5).
5.
If the device can't be found automatically, press "(+) Add Device Manually" and follow on screen instructions.
433 MHz devices
(Proove, Nexa)
1.
Go to Devices view
2.
Press (+) icon in the header
3.
Press "(+) Add Device Manually" and follow on screen instructions
