When you open Cozify application for the first time, the only device shown in your device view is the “timer”.
Sonos and Belkin Wemo devices will appear on your device list automatically after devices have been installed following the instructions provided by the device manufacturer.
Make sure, that all devices are connected to the same WiFi network as your Cozify Hub.
Zigbee devices
(Nyce sensors etc)
To add new Zigbee devices, you need to pair these devices with the Cozify hub. To activate pairing process, follow these steps:
Zigbee lights
(Philips Hue, Osram Lightify etc)
To add new Zigbee devices, you need to pair these devices with the Cozify hub. To activate pairing process, follow these steps:
Philips Hue with bridge
In case you are using Philips Hue lights and bulbs with Philips bridge, you need to allow Cozify hub to control the bridge. To add bridge, follow these steps:
Osram Lightify with gateway
In case you are using Osram Lightify lights and bulbs with Osram gateway, you have to unplug the gateway and initialize each light and bulb by turning it off and on for five times, between every 5 seconds.
After this you should have all the settings re-set to factory defaults. Now you can pair the lights and bulbs following the above instructions for adding new Zigbee lights.